Remote On/Off Switch with LCD Monitoring Screen for Any Power Combi, PSW7, High Power Inverter Charger

Description

This Remote LCD Screen only works with Sigineer Power Any Power Combi, PSW7, High Power pure sine inverter chargers with a RJ45 LCD remote port.

Pls make sure it works with your inverter before ordering. The buyer must pay for the freight cost both ways for return.

It is built with a three position on and off switch, an LCD display and a press bottom.
The three position on and off switch will power the inverter off or power it on ( in power saver on or power saver off mode).
The LCD displays inverter status including
Battery Voltage
AC input Voltage
AC Output Voltage
AC Input and Output Frequency
Load Percentage Monitoring
Inverter Alarms & Faults

The LCD screen to automatically go dim in a few seconds after the switch is operated, saving about 0.1A current draw on the battery bank.
The press bottom will allow the user to wake up the screen.
This LCD panel is flush mountable, it supports flush mount to surfaces like walls.
One most sought-after feature of the LCD remote is the compatibility with SNMP card for remote monitoring of the inverter status on the internet.
Click here to check out more about our SNMP Card.

For Remote LCD produced after Oct 2019, there is an optional 2-pin dry contact which allows use to power off the inverter by disconnecting the two pins. It is dedicated to use with Sigineer DC Voltage Dector.

If you want this dry contact, pls specify or give us a note before order.

Connection CAT-7 Cable with 8 Pin RJ45 connector

Cable Length: 33 foot/ 10m
Size(L x W x H):8″x4″x2.5″/20*10*5CM

Mounting hole size: 173*74mm

The LCD displays inverter status including

Battery Voltage
AC input Voltage
AC Output Voltage
AC Input and Output Frequency
Load Percentage Monitoring
Inverter Alarms & Faults

Connection Cable Length: 33 foot/ 10m

Size(L x W x H):8″x4″x2.5″/20*10*5CM